• 
  Equipment being installed on the north wall of the electrical room
• 
  Door and louver removed from SW corner of the electrical room
• 
  Contractor setting the precast concrete coping in the NW corner of the Clearwell Finished Pump Station
• 
  Welds inside the piping on the east area for the future piping for surge bladder tank

• 
  Welds on the outside of the piping on the east area for the surge bladder tank
• 
  Flow Control Valve on site
• 
  Flow Control valves on site
• 
  Working on piping on east side of the Clearwell

• 
  Finishing the brick wall on the NW corner of the Clearwell Finished Water Pump Station
• 
  Piping set on the main line on the west side of the Clearwell / Finished Water Pump Station, east side, south half
• 
  Piping set on the west side of piping on the east half of the Clearwell Water Pump Station
• 
  Door and louver removed in the SW corner of the electrical room

• 
  Getting ready to weld the outside edge of the tee for the FCV and surge relief valve
• 
  Getting ready to weld the outside edge of the tee for the FCU and surge relief valve, looking inside the weld
• 
  Electricians crew getting ready to bring one of the electrical SBC-C-1 into electrical room
• 
  Moving electrical panel to the inside of electrical room after door and louver removed

• 
  Electrical panel set on the north wall of the electrical room on the housekeeping pad
• 
  Weld on the tee for the FCU and surge relief valve
• 
  The tee welded for the FCV and surge relief east side (SE corner of Clearwell)
• 
  Corking in the Chlorine Contact Basin on patching, grinding and cleaning

• 
  Getting ready to weld 20”x18” reducer in the Clearwell, west side Water Pump Station
• 
  Welding the 20” x 18” reducer in the Clearwell west side Water Pump Station
• 
  Getting everything set up for re-doing 20” x 18” reducer on the west piping tee
• 
  Getting it lined up for re-doing the reducer on the piping tree

• 
  Looking inside the west piping reducing 20” x 18” on water line in Clearwell looking north to soth
• 
  Everything lined up to start welding on the west side waterline
• 
  One of the welds from the side on the 20” x 18” reducer
• 
  Another picture of the weld on the 18” x 20” reducer west side

• 
  Welder welding on the 20” x 18” reducer on the west side of the Clearwell east side
• 
  Bending rebar for the concrete pads in the electrical room for electrical panels
• 
  Cutting rebar for pads in the electrical room
• 
  Working on the piping tree at the north end of the east piping tree for the east / west Clearwell Finished Water Pump Station

• 
  Holes for the stud anchors on the copings
• 
  Forming for equipment housekeeping pads in the electrical room
• 
  Middle equipment housekeeping pads in electrical room
• 
  Working on north end of the Clearwell Pump Station piping tree

• 
  Filling the roof joist opening that were left so the block work could be done first, before the roof?
• 
  Filling the roof joist opening that were left so the block work could be done first?
• 
  Cutting opening for the FE-6-4 as shown on sht 4-M-1 on the east water line
• 
  Tree at the north end of the west and east water line for NPW and PW

• 
  Tree at north end of the west and east water line in the Clearwell
• 
  Unable to get a better picture, still a picture of the north most tree for NPW and PW (north end of Clearwell)
• 
  Rebar in the bottom of the floor above in the lower level of the Clearwell, it appears to be rebar that close, unable to get a good pic
• 
  Rebar in the bottom of the floor above in the lower level. Still unable to get a very good picture

• 
  Patching around a column in the bottom of Chlorine Contact Basin
• 
  Installing the 8” FW piping as shown in section E/4M1, see sht 4-M-4
• 
  Installing the precast concrete coping at the NW corner of the Clearwell Finished Water PumpStation
• 
  Concrete truck on site with materials for pads for the electrical room

• 
  Welding certification personnel on site to certify the contractors welder
• 
  Placing concrete pad in the center of the electrical room
• 
  Finishing curb in the roof of the Contact Chamber NE corner (roof vent)
• 
  Pouring the scuttle hatch in the NE corner of the Contact Chamber

• 
  Picture taken from roof over the Contact Chamber (roof vent and scuttle hatch)
• 
  On knoll looking SE to the Washwater Recovery Basin
• 
  Looking south over the Clearwell Finish Water Pump Station
• 
  Looking SW past the west half of the Clearwell Finish Water Pump Station

• 
  Looking south westerly by the storage and equipment building (trailers)
• 
  Looking west where equipment is being stored on the project site